![]() To find a resistor value: (5V - Vf)/.02A = lowest resistor value to use, higher is ok.Įxample Vf = 2.2V for a typical Red LED: (5V - 2.2V)/.02A = 140 ohm, use a 150ohm standard value resistor. LEDs have a forward voltage, Vf, that is the voltage you will measure across the leads when it starts to conduct. LEDs typically have a max continuous current of 20mA, if more current is allowed they overheat and their lifetime is reduced, or they fail.A trimmer with one outer leg at 5V and the other at Gnd can have any wiper position. ![]() Uno regulator and the reverse polarity protection diode are only rated for 1A.ĥV regulator is NCP1117 is rated for 800mA - but the part will overheat and go into thermal shutdown will before that if the barrel jack voltage is over 7.5V.ADC output will be 0 to 1023 (0x00 to 0x3F).
0 Comments
Leave a Reply. |